System board and components
Replacing the defective CMOS battery
1
Figure 252: Replacing the CMOS battery
▶ Press the locking spring into direction of the arrow (1), so that the CMOS
battery jumps out of its socket.
▶ Remove the CMOS battery (2).
CAUTION
Sharp tools such as screw drivers might damage system board
components in case of slipping.
▶
If the CMOS battery cannot be ejected without the help of a tool,
it is recommended to use a tooth pick.
▶ Insert a new CMOS battery of the same type into the socket (3) and (4).
Concluding steps
▶ Dispose of the CMOS battery in accordance with local regulations
concerning special waste.
▶
"Installing the air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
348
2
74.
57.
66.
Upgrade and Maintenance Manual
3
62.
4
66.
RX2530 M6