17.4
Minimum startup configuration
Field Replaceable Units
(FRU)
If the server does not start up or other problems occur, it may be necessary to
take the system down to its most basic configuration in order to isolate the
defective component.
The minimum startup configuration consists of the following components and
cables:
Component
System board
1 CPU with CPU heat
sink
1 memory module
Common Operation
Panel (COP)
1 PSU
Table 3: Minimum startup configuration - components
Cable
Front panel cable
Power cable
Table 4: Minimum startup configuration - cables
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶ Take the system down to its minimum startup configuration.
▶
"Connecting the power cord" on page
▶ Connect a display to the server.
▶ Switch on the server, see
RX2530 M6
Notes
no TPM or expansion cards installed
installed in CPU slot CPU 1
installed in DIMM slot 1A
installed in PSU bay PSU 1
Notes
48.
62.
"Switching on the server" on page
Upgrade and Maintenance Manual
49.
Appendix A
66.
425