Replacing A Riser Card - Fujitsu PRIMERGY RX2530 M6 Upgrade And Maintenance Manual

Expansion cards and backup units
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 92.
▶
"Updating expansion card firmware" on page
▶
"Resuming BitLocker functionality" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card).
Configuration of network settings should be performed by the
customer. For more information, see
recovery".
▶ If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
9.6.5

Replacing a riser card

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Locating the defective component" on page
▶ Remove the corresponding riser module, see
page 68.
232
101.
48.
Upgrade and Maintenance Manual
83.
93.
"Note on network settings
"After replacing or
Hardware: 5 minutes
45.
49.
52.
46.
"Handling riser modules" on
48.
RX2530 M6