Fujitsu PRIMERGY RX2530 M6 Upgrade And Maintenance Manual page 357

Figure 260: Removing the TPM spacer
▶ Using a flat nose pliers, press together the hooks on the TPM spacer (1, see
close-up) and remove it from the system board (2).
If the TPM is to be replaced, the TPM spacer may remain on the
system board.
Concluding steps
▶ Install all riser modules, see
▶ Install all fans, see
▶ Install the air duct, see
▶ Install the system board, see
▶
"Reassembling" on page
▶ If applicable, install the OCP modules, see
page 213.
▶ Install all PSUs, see
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
RX2530 M6
"Installing a riser module" on page
"Installing the new fan module" on page
"Installing the air duct" on page
"Installing the new system board" on page
57.
"Installing a hot-plug PSU" on page
66.
Upgrade and Maintenance Manual
System board and components
74.
"Installing the OCP module" on
62.
69.
192.
393.
110.
66.
357