Wexiodisk WD-6 DUPLUS Installation And User Manual page 26

Installation
2
3
1
Fitting the condensation unit
4 5
1. Position of the mounting points for the condensation unit
2. Bracket
3. Screw
4. Cover plate
5. Condensing unit
6. Screw and washer
• When the machine is delivered, the condensation unit (5) is folded down on
top of the machine. It is fastened to the bracket (2) with screws (3) during
transport. Remove the screws.
• The screws used to fit the condensation unit on the machine are screwed
into the mounting points on top of the machine (1). Remove the 5 screws.
• Remove the cover plate (4).
• Lift up the condensation unit (5) and fasten it to the machine at (1) using
the five screws and the flange provided.
• Fasten the condensation unit to both brackets (2) with the screws and
washers at (6).
• Fit the cover plate (4). The screws for the cover plate are supplied in a
plastic bag.
WD-6 DUPLUS
5
6
2
6
22
Rev. 4.0 (202202)
D337_1