LABORIE Nexam Pro WPU-L4 User Manual page 264

Message
DT-XX transducer not connected to CO2 module
Due to a change in the channel configuration
some approved events might have been set to
not approved. It is advised to re-analyse these
events
Error during backup [Filename]
Error during saving test data!
Error during saving test data! Investigation
number > 99
Error during saving test data! Not enough
memory available. Cannot perform
investigation.
Error in writing to file: [Filename]
Error while allocating MPEG4 buffers!
Error while allocating video buffers. Increase the
non-paged memory size in Milconfig.
Fatal error during reading of the testdata!
Fatal error occurred during the measurement!
Flowmeter not connected!
Flowmeter not connected! The LABORIE-bus
devices can only be used when the following
criteria are met: The Solar Blue is powered via
the power adapter. The Solar Blue is connected
to the computer via USB.
Illegal use of LABORIE software on a network
Incorrect serial port selected. Blood pressure
recording not possible. Change serial port
settings and restart the test.
Invalid character encountered - use only hex
digits 0...9, A...F
Luna Cond not present
Luna connection lost.
Luna EMG not present
Luna P1 not present
Luna P2 not present
Luna P3 not present
MEMORY FULL **** DATA IS NOT SAVED NOW!
264
Cause
Transducer expected but not
connected
Events problem
N/A
General error during saving test
data
Investigation number > 99
Not enough memory available
Error during save to demo file
MPEG4 buffer problem
Error while allocating video
buffers
Exception during reading test data Contact your LABORIE
Exception during measurement
Module expected but not
connected
Module expected but not
connected
Application cannot be started
from network location
Incorrect serial port selected
Invalid character in catheter string
to decode
Luna channel expected but not
present
Communication problems
Luna channel expected but not
present
Luna channel expected but not
present
Luna channel expected but not
present
Luna channel expected but not
present
Memory full, Investigation took
longer than expected
Nexam Pro User Manual
Posible actions to
resolve
Contact your LABORIE
representative
Re-analyse events
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Retry save as demo file
Contact your LABORIE
representative
Increase the non-paged
memory size in
Milconfig
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Start application from
LABORIE database
Change serial port and
restart test
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Stop the investigation
and start a new
investigation if
applicable
Appendix C