Installing A Sata Dom Module; Installing A So-Dimm - Nexcom VTC 1911 User Manual

Vehicle telematics computer

Table of Contents

Chapter 4: System Setup

Installing a SATA DOM Module

1. Locate the SATA slot (CN4). Insert the SATA DOM module into the SATA

slot at a 90 degrees angle until the SATA connector completely fits

inside the slot.

1. Push the ejector tabs which are at the ends of the socket outward. Then

insert the module into the socket at an approximately 30 degrees angle.

Apply firm even pressure to each end of the module until it slips down

into the socket. The contact fingers on the edge of the module will

almost completely disappear inside the socket.

VTC 1911 User Manual

Table of Contents

Do you have a question about the VTC 1911 and is the answer not in the manual?