Troubleshooting; Problem: The Nvr Does Not Turn On; Problem: The Nvr Automatically Shuts Down Or Stops Running; Problem: The Nvr Cannot Detect The Hard Drive - Honeywell HEN04112 User Manual

Troubleshooting

The following section describes possible problems and solutions. Refer to these
troubleshooting steps before calling Technical Support. If you still require assistance, call
Honeywell Technical Support at 1-800-323-4576 (North America only) or send an e-mail to
https://www.honeywellsystems.com/ss/techsupp/index.html. International contact information is
listed on the back cover.

Problem: The NVR does not turn on.

•
•
•
•
•

Problem: The NVR automatically shuts down or stops running.

•
•
•

Problem: The NVR cannot detect the hard drive.

•
•
•
Check that the input voltage is correct.
Check that the power cable is connected correctly to the NVR.
Check that the power switch is in the ON position.
Check that there is power at the outlet. Try connecting the NVR to another outlet or test the
outlet with another device.
Remove the housing and check that the hard drive cables are firmly connected.
Check that the NVR is receiving power and that the input voltage is correct and stable.
Make sure that the working environment is within the specified temperature range and is
free of dust. See Appendix D,
Remove the housing and check that the hard drive cables are firmly connected.
Remove the housing and check that the hard drive cables are firmly connected.
Inspect the hard drive and ribbon for damage. Replace if damaged.
Inspect the main board SATA port for damage. Replace if damaged.
Specifications.
12
800-21090V2 - A - 03/2016
12