Configuring Network Event Settings; To Configure Network Event Settings - Honeywell HEN04112 User Manual

5.

Configuring Network Event Settings

To configure network event settings

1.
2.
3.
4.
5.
• Send Email Select the check box to enable the system to send an email notification.
To set up Email settings, see
• Buzzer Select the check box to activate a buzzer noise at the NVR.
Click Apply to save your settings.
Go to Main Menu > SETTING > EVENT > ABNORMALITY > Network.
Figure 8-9 Network Abnormality Configuration Tab
On the Network tab, in the Event Type box, select the event type for which you want to
configure settings: Net Disconnection, IP Conflict, MAC Conflict.
Select the Enable check box to enable network error detection.
Select the actions that you want the system to initiate when the selected event occurs:
• Alarm Out Select the check box to activate the selected alarm output(s) (1 or 2). In
the Latch box, specify the amount of time (1–300 s) to delay the alarm
output signal after the network event is triggered.
• Show Message Select the check box to enable a pop-up message on your local host PC.
• Send Email Select the check box to enable the system to send an email notification.
To set up Email settings, see
• Buzzer Select the check box to activate a buzzer noise at the NVR.
Click Apply to save your settings.
Configuring Event Settings | 109
Configuring Email Settings on page 93.
Configuring Email Settings on page 93.
800-21090V2 - A - 03/2016