Configuring Video Masking (Tampering) Settings
To configure video tampering settings
1.
2.
3.
4.
5.
6.
7.
Go to Main Menu > SETTING > EVENT > DETECT > Video Masking.
Figure 8-7
Video Masking Configuration Tab
On the Video Masking tab, in the Channel box, select the channel (camera) for which you
want to configure video tampering detection settings.
Select the Enable check box to enable video tampering detection for the selected
channel.
To set the periods when video tampering detection is active, next to Period, click Set, and
then follow the steps listed in
To set the actions that you want the system to initiate when a video tampering event
occurs, follow the steps listed in
Click Apply to save your settings.
To copy the settings to additional channels, click Copy, select the channels to which you
want to copy the settings, and then click OK.
To set up motion detection periods
To set up motion detection event actions
Configuring Event Settings | 107
on page 103.
on page 104.
800-21090V2 - A - 03/2016