Plug Removal; Figure 22: Pulling The Pull Tab; Figure 23: Removing The Plug Without Tools; Figure 24: Removing The Plug Using A Screwdriver - WAGO 750 Series Manual

753-646 KNX/EIB/TP1 Module
6.3.2

Plug Removal

1. Remove the plug from the I/O module by pulling the orange pull tab on the
plug toward the top of the I/O module.

Figure 22: Pulling the Pull Tab

The plug detaches from the I/O module.

Figure 23: Removing the Plug Without Tools

2. Alternatively, you can also use a standard screwdriver at the position
shown (in the figure below) to remove the plug.

Figure 24: Removing the Plug Using a Screwdriver

Mounting 41
Manual
Version 1.1.0