GRAUPNER 33124 Manual page 53

Control/fix sw
C1 C2 C3 C4 FX
FXi C1i C2i C3i C4i
Use the arrow keys in the left or right key pad to select
the desired switch then assign it with a brief tap on the
center SET key of the right touch pad.
Notices:
• The two FX switches turn a function on "FXI" or off
"FX " permanently.
• All other switches mentioned can have multiple
assignments. Pay attention that you do not
UNINTENTIONALLY assign reciprocally confl icting
functions to a single switch. If necessary, note down
the given switch functions.
Application examples:
• Shut-off of an on-board glow plug heater upon
underrun or overrun of an idle threshold point
programmed for the C1 joystick. In this case the glow
plug heater switch is controlled by a transmitter mixer.
• Automatic switch on/off of the timer to measure pure
"fl ight time" for a helicopter by way of a control switch
on the throttle limiter.
• Automatic switch off of the "AI Rud" when brake
fl aps are extended, for example to adapt the roll of
a model to the ground when making a landing on a
slope without inducing a change of fl ight direction
due to infl uence on the rudder.
• Extending landing fl aps with elevator trim adjustment
during a landing as soon as the throttle stick is
moved beyond its switch point.
• Switch on/off of the timer for measuring the operating
time of electric motors.
The control switches, freely programmable in the
"Control switch" menu, can be incorporated into
switch programming, i. e. assigned to a function instead
of a "normal" switch. At those program locations
where switches can be assigned you always have the
opportunity to assign one of the control switches, C1...
C4, instead of a physical switch by selecting one of
these out of the list of "external switches".
Physical control, switch and control switch assignments 53