Code Lock - GRAUPNER 33124 Manual

Code lock

Locking of the multifunction list
Scroll with the arrow keys of the left or right touch pad to
the menu item ...
Telemetr y
Basic settings
Ser vo display
Ser vo test
Code lock
info display
... of the multifunction menu. By briefl y pressing the
central SET key of the right touch pad, this menu item
opens:
CODE LOCK
De s ir e d ( n ew )
s e c r e t num b e r
(_
1 2 3 3 4
SET
Access to the multifunction menu can be locked for
unauthorized use by a four-digit secret code comprised
of the numbers 1 to 4, which you enter according to the
scheme shown in the display with the arrow keys of the
left touch pad; for example :
CODE LOCK
D es ir e d ( n ew)
s ec r e t nu m b e r
(123_)
1 2 3 3 4
CLR
As soon as you not enter the fourth number by pressing
one of the other arrow keys of the left touch pad, the
following notice appears in the display:
232 Detail program description - Control adjust
FAIL SAFE
Pos
hold
7 8 9 10 11 12
DELAY :
By briefl y pressing the central
pad, you confi rm the secret code and leave the menu.
By briefl y pressing the central
pad, on the other hand, you confi rm the active
in the bottom right in the display and thereby delete the
number you entered.
Make note of the secret code and keep it safe.
Otherwise, the transmitter must be sent in to
Graupner Service for decoding.
)
The lock becomes active the next time the transmitter
is switched on. However, the control remains ready
for operation. Calling the multifunction list and thereby
a model change, for example, is no longer possible
without entering the correct number combination:
CODE LOCK
D e si re d ( n ew )
1 2 3 3
A renewed attempt following an incorrect entry is only
possible after the lapse of a time-out.
0.25s STO
ESC key of the left touch
Deletion of the secret code
If the secret code should be deleted again at a later
SET key of the right touch
point in time, after opening this menu, immediately press
CLR fi eld
the central SET key of the right touch pad
The fi rst time you press the central
touch pad, the secret code is deleted (CLR):
se cr e t nu m ber
(_ )
4
SET
And the second time you press the key the empty input
fi eld is confi rmed (SET). The display shows:
CODE LOCK
Des i red (new)
Input error
s ec ret num ber
Time lock (123_)
1 2 3 3 4
CLR
twice :
CODE LOCK
Des i red (new)
s ec ret number
(1234)
1 2 3 3 4
CLR
SET key of the right
firmware ver. 1.234
date 2011/02/01(Mo )
time 11:22:33s
SD-Card 2048MB
available 1234MB