Table of Contents
Advertisement
Both LEDs on the receiver will illuminate during the
update process. Upon successful conclusion of the
update process, the green LED will extinguish and
the red LED will begin to blink.
Switch off the receiver, remove the interface cable
and repeat the process for any other receivers you
have which must be updated.
4.
Receiver initialization
Following a successful update process you MUST
perform a receiver initialization procedure before
using the receiver again. This is necessary for
reasons of safety.
Do this by pressing and holding the receiver's SET
button then switching the receiver's power supply
on. Now release the SET button again. When you
subsequently switch the receiver on again, the
receiver's green LED will illuminate continuously for
about 2 or 3 seconds. Except for binding information,
all other settings that may have been programmed
into the receiver will now be reset to factory defaults
and will have to be re-entered again if they are
needed.
Putting the transmitter into operation
45
Advertisement
Table of Contents
