GRAUPNER 33124 Manual page 258

Here, select the menu item "Copy fl ight phase" with the
arrow keys and then briefl y press the central
the right touch pad.
In the appearing window, "Copy from phase", "1 Normal"
is selected ...
Copy from phase:
1 Nor mal 2 Ther mal
3 Speed 4 Launch
5 6
7
... and then briefl y press the central SET
right touch pad, whereby the display switches to
"Copy to phase". Now the target is selected (initially "2
Thermal") and confirmed by pressing the central
key of the right touch pad again. After confi rmation of
the subsequent safety query, all settings are copied
according to the selection.
Proceed in the same manner with the other two phases
("1 Normal" to "3 Speed" and "1 Normal" to "4 Start").
4. Step
Now three or four phases are programmed, the settings
are also copied and there is even a "soft" transfer, but ...
there are still no fl ight-phase specifi c settings.
Now, if applicable, in order to adapt the fl ap positions to
the different requirements of the individual fl ight phases,
in the menu ...
"Control adjust"
... the standard default "GL" is fi rst changed to "PH" for
"Phase" in the type column:
258 Detail program description - Control adjust
Input 5
SET key of
Input 6
Input 7
Input 8
Nor mal
Then switch to the "Offset" column and make the
settings deviating from the "Normal" fl ight phase for the
=>
ailerons. However, switch to the desired fl ight phase
=>
beforehand, whose name is shown at the bottom in
the display, appropriate to the switch position. Both
positive and negative throw changes are possible. These
key of the
settings are to be made separately for each fl ight phase:
Input 5
SET
Input 6
Input 7
Input 8
Nor mal
5. Step
Any necessary phase-specifi c trimming of the elevator is
made with the help of the digital trimming of the elevator
joystick. This requires that you have at least set the
elevator trimming to "Phase" in the "Joystick setting"
menu - as already shown in this programming example.
Alternatively, you can also carry out these settings in the
"Phase trim" menu ...
(page 96)
PH ––– 0%
GL ––– 0%
GL ––– 0%
GL ––– 0%
typ offset
6. Step
In the menu ...
"Wing mixers"
... the fl ight phase name of the newly activated fl ight
phase appears at the bottom edge of the display. If
the switch position is now changed, the name of the
flight phase selected with the switch appears, but
PH ––– –7%
with the previously copied settings of the fl ight phase
GL ––– 0%
"Normal". Here you set you values phase-specifi cally
GL ––– 0%
for the aileron differentiation, the share of the mixture
GL ––– 0%
of transverse to side, and if applicable, also a mixture
of altitude to transverse. (The latter increases the agility
typ offset
over the transverse axis when "Turning".)
Notice:
The list of displayed options depends on the number of
servos entered in the "Ailerons/flaps" line in the "Model
type" menu.
Now switch to the submenu ...
Normal 0% 0%
Thermal 0% 0%
Speed 0% 0%
Launch 0% 0%
Thermal ELEV QR
(beginning on page 146)
WING MIXERS
Brake sttings
Aile.diff. 33%
AI RU 55% –––
EL FL 0% 0% –––
Thermal