GRAUPNER 33124 Manual page 226

"rear": minimum rear pitch setting, the pitch joystick
(C1) points towards the pilot.
Simultaneously pressing the keys or
right touch pad (CLEAR) switches to "rear"
Notice:
The stick mode of the C1 joystick in the winged model
program for "Throttle min front/rear" can be individual
changed in the "Model type" menu.
Contrast
In order to guarantee the optimal visibility of the display
of the mc-32 HoTT in any weather and at any
temperature, you can adjust its contrast:
GRAUBELE Stop
#01 Flt
«nor mal
5.2V HoTT
K78
2:22h
M
GRAUBELE Stop
#01 Flt
«nor mal
5.2V HoTT
K78
2:22h M
For this purpose, using the arrow keys
right touch pad, select the "Contrast" line:
226 Detail program description - Control adjust
BASIC SETTINGS
Stick mode
of the
DSC Output
Pitch min
Contrast
Then briefl y press the central
pad. Now you can adjust the display contract in a range
of ±20 using the arrow keys of the right touch pad in the
inverse value fi eld.
Simultaneously pressing the arrow keys
of the right touch pad (CLEAR) resets the inverse fi eld
to "0".
0:00
Display light
0:00
In this line you can determine how long the backlight of
»
the display should remain switched on after switching on
the transmitter or the last key actuation.
5.5V
The available options are "unlim(ited), "30 s", "60 s" and
"120 s".
Simultaneously pressing the arrow keys
0:00
of the right touch pad (CLEAR) sets the inverse fi eld to
0:00
"unlimited".
»
Power-on beep
5.5V
In this line you can switch the power-on beep of the
transmitter on ("yes") and off ("no").
of the left or
Simultaneously pressing the arrow keys
of the right touch pad (CLEAR) switch the inverse fi eld
back to "yes".
Battery type
1
PPM10
back
0
SEL
SET key of the right touch
In this line you indicate to the transmitter whether its
power supply is provided from a four-cell NiMH battery
or a single-cell LiPo battery. Depending on this setting,
or
you are offered a suitable voltage range in the (next) line
"Battery warning".
Simultaneously pressing the arrow keys
the right touch pad (CLEAR) switches back to "Ni-MH"
in the inverse fi eld.
Battery warning threshold
or
You can arbitrarily specify the warning threshold for the
display ...
or
... – depending on the selection of the battery type in
the line above it – in increments of 0.1 volt between 4.5
and 5.5 V (NimH battery) or 3.4 and 4.2 V (LiPo battery.
BASIC SETTINGS
Contrast 0
Display light unlim.
Power-on beep yes
Batter y type Ni-MH
SEL
or
BASIC SETTINGS
Display light unlim.
Power-on beep yes
Batter y type Ni-MH
Batter y warning 4.7V
SEL
batter y
needs
c hargi ng
of