GRAUPNER 33124 Manual page 151

Here, you can set the degree to which the rudder follows
commands acting on ailerons. This is used in particular
in connection with aileron differential to suppress
adverse yaw and thus make it easier to fl y "clean"
curves. You can of course still issue separate commands
to the rudder.
The adjustment range of ± 150% lets you set the
direction of defl ection as appropriate. Optionally, this
mixer can be activated and deactivated by using one of
the switches that do not reset themselves (SW 2 ... 8) or
a control switch. This means you can then also control
the model using only the ailerons or rudder, as required.
Typically, this mixer is set so that the rudder is defl ected
to the same side as the upward-oriented aileron, and
you will fi nd that setting a value of around 50% is usually
highly appropriate.
Settings are always made symmetrically relative to the
neutral point of the aileron joystick.
If you tap the or keys on the right touch
pad (CLEAR) at the same time, this will reset values
changed in the active (highlighted) fi eld back to 0%.
Elevator fl aps
WING MIXERS
Brake settings
AI RU 0%
EL FL
0% 0%
FL EL 0%
0%
Nor mal
To provide support for the elevator for tight turns
and aerobatics, this mixer can be used to make the
fl ap function follow controls sent to the elevator. The
mixer direction chosen must ensure that the fl aps are
defl ected downwards when the elevator is oriented
upwards and vice versa for a downward-oriented
elevator – i.e. in opposite directions. Optionally, this
mixer can be activated and deactivated by using one of
the switches that do not reset themselves (SW 2 ... 8) or
a control switch.
To confi gure symmetrical mixer values, move
the elevator joystick to its center position, so that
the marker frame surrounds both value fi elds. To
confi gure asymmetric values, move the joystick to the
corresponding side.
Values in the range -150% to +150 are possible, so as
to adjust the function to the direction of servo rotation or
direction of fl ap defl ection.
If you tap the or
pad (CLEAR) at the same time, this will reset values
changed in the active (highlighted) fi eld back to 0%.
The "typical" values confi gured for this mixer are single-
digit or low two-digit values.
Flaps elevator
WING MIXERS
Brake settings
AI RU
EL FL
FL EL
–––
Nor mal
–––
–––
This mixer is used to set elevator (pitch-trim)
compensation when a fl ap command is given. This
typically enables you to adjust the model's airspeed
automatically when fl aps are lowered.
If you have used the "Control adjust" menu (page 96)
to assign input 6 a transmitter control or switch –
possibly fl ight phase-dependent – then this also affects
this mixer.
Depending on the position of the fl ap control, either
a symmetrical or asymmetric setting within the range
±150% is possible.
If you tap the
pad (CLEAR) at the same time, this will reset values
changed in the active (highlighted) fi eld back to 0%.
If required, the mixer can be switched on or off by
assigning a switch in the right column.
The values confi gured for this mixer are typically in the
single-digit range.
keys on the right touch
0% –––
0% 0% –––
0% 0% –––
Detail program description - Control adjust
or keys on the right touch
151