Pr-2000 Control Panel; Indications On The Control Panel; Turning On The Welder - Pro Spot PR-2000 Instruction Manual

PR-2000

4.2.3 PR-2000 Control Panel

4.2.4 Indications on the Control Panel

Figure 4.4

4.3 Turning on the welder

Figure 4.5.1
Copyright © Pro Spot International, Inc. 2005-2009
Figure 4.3 The PR-2000 Control Panel
When two sided welding is selected, a spot gun graphic appears in the upper-left
corner of the display screen (fig. 4.4).
When single sided welding is selected, a single sided gun graphic appears in the
upper-left corner of the display screen (fig. 4.5).
Figure 4.5
1. Toggle the circuit breaker on the front panel to "ON". Three lights on the
front panel should illuminate indicating 3-phase installation, 2 lights for 1-
phase installation (fig. 4.5.1)
2. The display will go through the start-up procedure and automatically default to
Two-Sided welding.
3. The PR-2000 is now ready to use.
IMPORTANT! Make sure to read the instruction manual before operating
the welder. Only trained personell should use this welder.
4 Operation
Page 12