Table of Contents
Advertisement
Hybrid Spot
4.2.3 Hybrid Spot Control Panel
4.3 Turning on the welder
All Info Copyright © Pro Spot International Inc.
80
Batt1
15.30V
Batt2
15.30V
Batt3
15.30V
Batt4
15.30V
ELECTRODE
PRESSURE
CHARGING
DC AMPS
BAT 1
Figure 4.3 The Hybrid Spot Control Panel
1. Toggle the power switch on the front panel to "ON".
2. The Hybrid Spot is now ready to use.
3. The System Display window will show the battery
voltage & charge current on all four batteries.
4. The weld toggle switch must be in position "WELD" to perform welding
duties. Start with 3 batteries ON, (BAT 1, 2, 3 switches ON) and adjust
the weld time to 260-300. If more power is required, turn BAT 4 ON.
5. Increase the WELD TIME knob if a longer weld time is needed. NOTE: An
increased weld time will drain the batteries quicker. Also, always clean and
sharpen weld electrodes to maintain welding performance.
IMPORTANT! Make sure to read the instruction manual before operating
the welder. Only trained personnel should use this welder.
IMPORTANT! Assurez-vous de lire le Mode d'Emploi avant d'opérer
le soudeur. Seul le personnel qualifié devrait utiliser ce soudeur.
1.5A
1.5A
1.5A
SERVICE
1.5A
PUSH TO
TEST BATTERY
ON
BAT 1
BAT 2
CHARGING
CHARGING
DC AMPS
DC AMPS
BAT 2
BAT 3
HYBRID SPOT
4 Operation
ON
POWER
OFF
READY
WELD
BAT 1
TEST
260
BAT 2
190
300
TEST
BAT 3
TEST
120
350
BAT 4
TEST
WELD
TIME
ON
ON
ON
BAT 3
BAT 4
CHARGING
DC AMPS
BAT 4
PHS-100
Page 12
14
Advertisement
Table of Contents
