Oil Pressure Indicator Inspection; Oil Pressure Switch Removal And Installation; Ignition Switch Inspection; Ignition Switch Removal And Installation - Suzuki VLR1800 Service Manual

9C-8 Combination Meter / Fuel Meter / Horn:

Oil Pressure Indicator Inspection

Inspect the oil pressure indicator in the following
procedures:
NOTE
Before inspecting the oil pressure switch,
check if the engine oil level is correct. Refer
to "Engine Oil and Filter Replacement in
Section 0B (Page 0B-11)".
1) Disconnect the oil pressure switch lead wire (1) from
the oil pressure switch.
2) Turn the ignition switch ON.
3) Check if the oil pressure indicator (LED) and LCD
will light up when grounding the lead wire (1).
If the oil pressure indicator does not light up, replace
the combination meter unit with a new one after
checking the connection of couplers.
1

Oil Pressure Switch Removal and Installation

Refer to "Oil Pressure Switch Removal and Installation in
Section 1E (Page 1E-7)".
B822H19306013
1
I822H1930018-01
I822H1930019-04
B822H19306014

Ignition Switch Inspection

Inspect the ignition switch in the following procedures:
1) Remove the left frame cover. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)".
2) Disconnect the ignition switch coupler (1).
3) Inspect the ignition switch for continuity with a tester.
If any abnormality is found, replace the ignition
switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
R
Position
OFF
ON
P
4) After finishing the ignition switch inspection, reinstall
the removed parts.

Ignition Switch Removal and Installation

Refer to "Ignition Switch Removal and Installation in
Section 1H (Page 1H-10)".
B822H19306015
1
I822H1930020-01
O O/Y Gr Br
I822H1930021-06
B822H19306016