Universal Joint Removal And Installation - Suzuki VLR1800 Service Manual

3A-22 Drive Chain / Drive Train / Drive Shaft:
Spring
Inspect the spring damage or fatigue. If any defects are
founds, replace the spring with a new one.
Oil Seal
Inspect the oil seal for wear and damage. If any defects
are found, replace the oil seal with a new one.

Universal Joint Removal and Installation

Removal
1) Remove the swingarm. Refer to "Swingarm /
Cushion Lever Removal and Installation in Section
2C (Page 2C-5)".
2) Remove the universal joint (1) and boot (2).
I822H1310087-01
Installation
Install the universal joint in the reverse order of removal.
Pay attention to the following point:
• Before installing the swingarm, install the boot and the
universal joint.
NOTE
Make sure that the "UP" mark "A" on the
boot faces to up.
I822H1310110-01
I822H1310090-02
1
2
"A"
B822H13106018
I822H1310091-02
"A"
I822H1310092-03