Suzuki VLR1800 Service Manual page 464

3A-6 Drive Chain / Drive Train / Drive Shaft:
11) Remove the driven gear stopper with the special
tool.
Special tool
(D): 09921–20240 (Bearing remover set)
12) Remove the bearing (14) and oil seal housing (15)
with the special tool.
Special tool
(D): 09921–20240 (Bearing remover set)
15
13) Remove the bearing (16) with the special tools.
Special tool
(E): 09941–64511 (Bearing remover)
(F): 09930–30104 (Rotor remover slide
shaft)
16
(D)
I822H1310021-01
(D)
14
I822H1310022-01
(E)
(F)
I822H1310014-01
Assembly
1) Install the bearings with the special tool.
CAUTION
!
The removed bearing must be replaced with a
new one.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09913–70210 (Bearing installer set)
(A)
2) Apply bond to the mating surface of the bearing
housing and oil seal housing.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
NOTE
• Make surface free from moisture, oil, dust
and other foreign materials.
• Take extreme care not to apply any bond to
the bearing.
(A)
I822H1310015-01
I822H1310016-02