Ignition Coil Removal and Installation
Removal
1) Turn the ignition switch OFF.
2) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-8)".
3) Remove the frame head cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-3)".
4) Disconnect the reservoir hose and mounting bolt (1).
1
5) Loosen the water hose clamp and remove the
condition hose (2) along with radiator conduction.
6) Disconnect the ignition coil lead wires (3).
3
B822H11806009
I822H1180005-01
2
I822H1180006-01
I822H1180007-01
7) Remove the ignition coil (For #2 cylinder) (4) by
disconnecting the high tension cord.
8) Remove the battery carrier. Refer to "Battery /
Battery Holder Removal and Installation in Section
1J (Page 1J-11)".
9) Disconnect the ignition coil read wires (5) and
disconnect the high tension cord.
10) Remove the ignition coil (For #1 cylinder) (6).
6
Installation
Install the ignition coils in the reverse order of removal.
Pay attention to the following points:
• Route the each wiring harness properly. Refer to
"Wiring Harness Routing Diagram in Section 9A
(Page 9A-7)".
• Install the radiator conduction and conduction hose.
Refer to "Water Hose Routing Diagram in Section 1F
(Page 1F-3)".
• Pour engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page 0B-15)".
Ignition System:
1H-5
4
I822H1180008-01
5
I822H1180009-01