∗ COOLANT HEATER
Is mounted on the right side of engine
block.
output
1000 W
voltage 220 V
DRIVING OPERATION
C209
STARTING THE ENGINE WHILE USING COOLANT HEATER
With low temperatures of the surroundings, engine starting eases heating coolant.
Lead-in electrical installation and its protection against dangerous contact must be
done pursuant to valid regulations
1.
First plug the plug to the heater.
2.
Then connect heater to electrical network of the voltage of 220 V.
With regard for the lower engine wear with low temperature, the use of heater is
recommended by manufacturer. The duration of heating is dependent on the sur-
rounding temperature (1 – 2 hours before the expected start).
After completing the heating, disconnect the device first from electrical net-
work and only then disconnect the plug from the heater!
Danger of injury due to electricity!
It is necessary to ensure tractor operator's instruction and regular revi-
sion of coolant heater including feeding cable pursuant to valid legisla-
tion of the state where the tractor is operated at least prior to each win-
ter period.
43
G210a