Gpio (Digital Input/Output Settings) - IAI GOX-2402M-USB User Manual

GPIO (Digital Input/Output Settings)

The unit can input/output the following signals to and from external input/output
connectors.
External output
Line2 : Opt Out
External input
Line5 : Opt In
These signals can be used as triggers and other necessary signals within the camera or
as signals output from the camera to the system, such as those used for lighting
equipment control.
Use the [Digital I/O Control] to set the digital input / output.
Select input or output in [LineSelector], you can check [LineMode], [LineFormat] and set
[LineInverter].
You can also check the status of each digital I/O as shown in the table below with
[LineStatusAll].
LineSelector
LineMode
Line2 Output
Line5 Input
Nand0In1 Input
Nand0In2 Input
Nand1In1 Input
Nand1In2 Input
TimestampReset
Internal Connection
For digital output, set the output source signal using [LineSource].
Set the source signal in the same way for NAND Logic (Nand0In1, Nand0In2, Nand1In1,
NandIn2) and TimestampReset.
The table below shows the source signals that can be set.
LineSelector
Line2
Line5
Nand0In1
Nand0In2
Nand1In1
Nand1In2
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
TimestampReset
DC IN / TRIG IN connector (6-pin round)
DC IN / TRIG IN connector (6-pin round)
LineFormat LineInverter
OptoCoupled True/False
OptoCoupled False (fixed)
InternalSignal True/False
InternalSignal True/False
InternalSignal True/False
InternalSignal True/False
InternalSignal False (fixed)
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
— 28 —
LineStatusAll
bit1 DC IN / TRIG IN connector (6-pin round)
bit4 DC IN / TRIG IN connector (6-pin round)
✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓
Go-X Series USB3 Vision I/F
✓ ✓ ✓ ✓
✓ ✓ ✓ ✓