IAI GOX-2402M-USB User Manual page 61

Item
e) AcquisitionControl
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionFrameCount
AcquisitionFrameRate(Hz)
TriggerSelector
TriggerMode
TriggerSoftware
TriggerSource
TriggerActivation
TriggerOverlap
TriggerDelay (us)
ExposureMode
ExposureTime (us)
ExposureAuto
ExposureModeOption
Setting range Default value
0:SingleFrame 2:Continuous
1:MultiFrame
2:Continuous
ー ー
ー ー
1〜65535 1
0.125〜
0:AcquisitionStart 0:AcquisitionStart
1:AcquisitionEnd
3:FrameStart
4:AcquisitionTransferStart
Off, On Off
0: Low ー
1: High
2: Software
10: PulseGenerator0
14-17: UserOutput0-3
21: Line5 Opt In1
26: Nand0 Out
27: Nand1 Out
1:Rising Edge, 1:RisingEdge
2:Falling Edge,
3:Level High,
4:Level Low
0:Off, 1:ReadOut ー
0〜500000 0
0:Off 0:Off
1:Timed
2:TriggerWidth
1μs 〜 ー
0:Off Off
1:Once
2:Continuous
0:Off Off
1:RCT
Configure image capture settings.
Select the image capture mode.
Start image capture.
Stop image capture.
In [MultiFrame] mode, set the number of frames to capture.
Set the frame rate as a frequency. (unit: Hz)
The maximum value varies depending on the PixelFormat and ROI settings.
Select the trigger operation.
Select the trigger mode.
Execute a software trigger.
Select the trigger signal source.
Select the polarity of the trigger signal (i.e., location of signal at which trigger
is applied).
Select the trigger overlap operation.
TriggerOverlap[AcquisitionStart]
TriggerOverlap[AcquisitionEnd]
TriggerOverlap[FrameStart]
TriggerOverlap[AcquisitionTransferStart] = Off (Fixed)
Set the time of exposure start from trigger input. (unit: μs)
Select the exposure mode.
Set the exposure time. The specifiable range varies depending on the
[StartTriggerMode] and [PixelFormat] setting.
Set whether to enable auto exposure.
Set whether to enable RCT mode.
— 61 —
Go-X Series USB3 Vision I/F
Description
= Off (Fixed)
= Off (Fixed)
= ReadOut (Fixed)