IAI GOX-2402M-USB User Manual page 67

Item
o) CounterAndTimerControl
CounterSelector
CounterEventSource
CounterEventActivation
CounterReset
CounterRefresh
CounterValue
CounterStatus
p) ChunkDataControl
ChunkModeActive
ChunkOffsetX
ChunkOffsetY
ChunkWidth
ChunkHeight
ChunkLineStatusAll
ChunkExposureTime
ChunkGainAnalogAll
ChunkGainDigitalRed
ChunkGainAnalogBlue
ChunkFrameTriggerCounter
ChunkSequencerSetActive
q) TestControl
TestPendingAck (ms)
r) UserSetControl
UserSetSelector
UserSetLoad
UserSetSave
Setting range Default value
0:Counter0, 1:Counter1, ー
2:Counter2, 3:Counter3
ー Off
ー ー
ー ー
0〜65535 0
0〜65535 0
ー ー
True, False False
ー ー
ー ー
ー ー
ー ー
ー ー
ー ー
ー ー
ー ー
ー ー
ー ー
0〜10000 0
Default, UserSet1, Default
UserSet2, UserSet3
0(default), 1, 2, 3 ー
1,2,3 ー
Configure counter settings.
Select the counter.
Assign the counter event signal for which you want to read the count value to
a dedicated counter, and read the value.
Counter0 0:Off, 1:FrameTrigger
Counter1 0:Off, 3:SensorReadOut
Counter2 0:Off, 2:ExposureStart
Counter3 0:Off, 4:FrameTransferEnd
Set the count timing.
The setting value is fixed with the following data.
Counter0:RisingEdge, Counter1:RisingEdge, Counter2:RisingEdge, Counter3:FallingEdge
Reset the counter.
Update the count value.
Display the count value.
Display the counter status.
0:CounterIdle: Idle
2:CounterActive: Counting
4:CounterOverflow: Count value exceeded the mazimum value
Configure chunk control settings.
Set whether to enable ChunkData.
The value of OffsetX (ChunkID 2000h : DataType Integer)
The value of OffsetY (ChunkID 2001h : DataType Integer)
The value of Width (ChunkID 2002h : DataType Integer)
The value of Height (ChunkID 2003h : DataType Integer)
The value of LineStatusAll (ChunkID 2013h : DataType Integer)
The value of ExposureTime (ChunkID 2004h : DataType Integer)
The value of AnalogGainAll (ChunkID 201Fh : DataType Float)
The value of DigitalGainRed (ChunkID 2006h : DataType Float)
The value of AnalogGainBlue (ChunkID 2007h : DataType Float)
The value of FrameTriggerのCounter (ChunkID 200Eh : DataType Integer)
The value of SequencerSetActive (ChunkID 200Ch : DataType Integer)
PendingAck function test command.
The camera waits for TestPendingAck (ms) time and returns an Ack response.
Configure user settings.
Select the user settings.
Load user settings.
(If 0 is specified, the factory default setting is read.)
Save the current setting values as user settings.
— 67 —
Go-X Series USB3 Vision I/F
Description
(This camera only supports counter functions.)