Table of Contents
Advertisement
Main Functions
GPIO (Digital Input/Output Settings)
The unit can input/output the following signals to and from external input/output connectors.
External output
TTL Out (Line1)
External input
TTL IN (Line4)
CC1 (Line7)
These signals can be used as triggers and other necessary signals within the camera or as signals
output from the camera to the system, such as those used for lighting equipment control.
Signals are selected as follows.
• When using external signals or the signals of each GPIO module as trigger signals:
Select in [Trigger Selector] > [Trigger Source].
• When selecting the signals to use for external outputs:
Select in [Line Selector] > [Line Source].
Camera Output Formats
The SW-8000M-PMCL supports a variety of output formats.
The supported tap geometries are as follows.
The tap geometry settings on the camera side and the frame grabber board side must match. For
details on frame grabber board settings, refer to the instruction manual of the board.
Tap geometry
1X2
1X3
1X4
1X8
1X8
1X10
*
1
Effective pixels are restricted to 8184.
*
2
Effective pixels are restricted to 8180.
■ Cable length reference
The Camera Link cable length is 10 m or less. The length of cable is 3 m or less when use CL Pixel
Clock 84.82MHz, Tap Geometry 1x10.
*
3
The length of cable you can use will also vary depending on type and maker.
Exposure Mode
The following operation modes are available on the camera.
Operation mode
Exposure Mode
OFF
Timed
PWC
DC IN / trigger IN connector (12-pin round)
DC IN / trigger IN connector (12-pin round)
Camera Link cable
CL configuration
Base
Base
Medium
Full
80 bit (Deca)
80 bit (Deca)
*3
Trigger Mode
OFF
ON
OFF
ON
ON
— 20 —
bit: 8/10
bit: 8
bit: 8/10
bit: 8
bit: 10
bit: 8
Command
TR
TG
0
0
1
0
1
1
2
1
SW-8000M-PMCL
*1
*2
Advertisement
Table of Contents
