Connecting The Converter To Profibus; What Do You Have To Set For Communication Via Profibus - Siemens SINAMICS G120D Operating Instructions Manual

Installation

4.4 Connecting the converter to PROFIBUS

4.4 Connecting the converter to PROFIBUS
The PROFIBUS DP interface has the following functions:
• Cyclic communication
• Acyclic communication
• Diagnostic alarms
General information on PROFIBUS DP can be found in the Internet:
•
•
4.4.1

What do you have to set for communication via PROFIBUS?

Configuring PROFIBUS communication
You require the appropriate engineering system to configure PROFIBUS communication in the
PROFIBUS master.
If required, load the GSD file of the converter into the engineering system.
Setting the address
Set the address of the PROFIBUS slave.
Setting the telegram
Set the same telegram in the converter as in the PROFIBUS master. Interconnect the telegrams
in the control program of the PROFIBUS master with the signals of your choosing.
72
PROFIBUS user organization (http://www.profibus.com/downloads/installation-guide/)
Information about PROFIBUS DP (www.siemens.com/profibus)
Installing the GSD (Page 73)
Set the PROFIBUS address (Page 74)
Drive control via PROFIBUS or PROFINET (Page 131)
Converter with the control units CU240D-2
Operating Instructions, 10/2020, FW V4.7 SP13, A5E34262100B AH