Siemens SINAMICS G120D Operating Instructions Manual page 132

Advanced commissioning
8.4 Adapt the default setting of the terminal strip
The deadband acts on the zero crossover of the analog input characteristic. Internally, the
converter sets its speed setpoint = 0, even if the signal at the analog input terminals is slightly
positive or negative. This prevents the converter from rotating the motor when the speed
setpoint = 0.
Parameters
Parameter
p0764[0]
p0764[1]
130
Description
Analog inputs deadband, AI 0
Analog inputs deadband, AI 1
Operating Instructions, 10/2020, FW V4.7 SP13, A5E34262100B AH
Factory setting
0
0
Converter with the control units CU240D-2