Switching To Standby - WAGO 761-114 Manual

WAGO-TO-PASS® 761
761-114 Telecontrol Module Compact, 2 AI, Web, MODBUS485
8.4

Switching to Standby

Standby authorization
Switching standby on and off is only possible by subscribers whose telephone
number has been entered in the address list!
Using the "Standby" function, it is optional to change all messages sent by the
TO-PASS
takes place with simple changeover via SMS.
To do this, just send an SMS with the text "Standby1" to the TO-PASS
telecontrol modules. The TO-PASS
messages to the SMS sender. Other receivers defined in the TO-PASS
modules are no longer informed.
To switch this function off, send an SMS with the text "Standby0" to the TO-
®
PASS telecontrol modules.
The TO-PASS
of the standby function and the "STANDBY END!" at the end of the standby
function.
Manual
Version 1.0.0
®
telecontrol modules specifically to the respective ready state. This
®
telecontrol module sends the SMS "STANDBY OK!" at the start
®
telecontrol module then transmits all alarm
Operation 95
®
®
telecontrol