Switching To Standby - WAGO -TO-PASS 761 Manual

Telecontrol module for fault detection/indication, monitoring and remote control
Hide thumbs Also See for WAGO-TO-PASS 761:
Table of Contents

Advertisement

76
Remote Polling using the TO-PASS® Operating Program
7.2.1

Switching to Standby

Standby authorization
Switching standby on and off is only possible by subscribers whose telephone
number has been entered in the address list!
Using the "Standby" function, it is optional to change all messages sent by the
TO-PASS
takes place with simple changeover via SMS.
To do this, just send an SMS with the text "Standby1" to the TO-PASS
telecontrol modules. The TO-PASS
messages to the SMS sender. Other receivers defined in the TO-PASS
modules are no longer informed.
To switch this function off, send an SMS with the text "Standby0" to the TO-
®
PASS
telecontrol modules.
The TO-PASS
of the standby function and the "STANDBY END!" at the end of the standby
function.
®
telecontrol modules specifically to the respective ready state. This
®
telecontrol module sends the SMS "STANDBY OK!" at the start
761-210 Telecontrol Module Compact
®
telecontrol module then transmits all alarm
WAGO-TO-PASS® 761
®
®
telecontrol
Manual
Version 2.0.0

Advertisement

Table of Contents
loading

This manual is also suitable for:

761-210

Table of Contents