Acknowledgement; Figure 30: : Configuring The Acknowledgment Response; Table 31: Configuring The Acknowledgement Response - WAGO 761-114 Manual

WAGO-TO-PASS® 761
761-114 Telecontrol Module Compact, 2 AI, Web, MODBUS485
7.6.4

Acknowledgement

Acknowledgment is the confirmation that a message has actually been sent to the
recipient. Select the TO-PASS
identifier. Select the entry Acknowledgment under the option Special Functions.
The right side contains the input fields for the waiting time, the number of
repetitions and the response text.

Figure 30: : Configuring the acknowledgment response

Table 31: Configuring the acknowledgement response

Settings
Waiting time
Repetitions
Response text
Manual
Version 1.0.0
®
telecontrol module from the project tree using the
In this field enter the time that the TO-PASS
module waits for an acknowledgement after transmitting an
alarm SMS.
Acknowledgement is in the form of an SMS containing the
configured response text, or a simple call by the recipient to
®
the TO-PASS telecontrol module.
®
The TO-PASS telecontrol module registers the call.
You then receive an acknowledgement SMS containing the
identifier, the response text and the alarm text.
In this field enter the number of acknowledgement cycles.
If no recipient acknowledges the message of the TO-PASS
telecontrol module, then the entire cycle can be executed
again, allowing the TO-PASS
the first address once again and to wait for an
acknowledgment.
In this field enter the SMS acknowledgement text (up to 20
characters).
This input field is available starting with Firmware Version
FW 2.33.
Parameterizing
®
telecontrol
®
telecontrol module to inform
71
®