Selecting And Setting; Monitoring Settings And System Settings; Changing The Ventilation Mode - Dräger Fabius Tiro Instructions For Use Manual

Operating concept
D Volume monitoring
Display of:
– Respiratory rate of the patient in breaths
per minute (Freq)
– Tidal volume (VT)
– Minute volume (MV)
– Upper and lower alarm limits of the minute
volume

Selecting and setting

Monitoring settings and system settings

Each of these settings requires a selection and
confirmation by pressing the rotary knob.
– To change a value or parameter or to navigate
in the menus, turn the rotary knob.
In this document, these procedural steps are
simply called "select."
– To confirm a value or a selection, press the
rotary knob.
Without confirmation with the rotary knob the value
or parameter is not changed. In this document,
these procedural steps are simply called "confirm."
46
E Airway pressure monitoring
Display of:
– Positive end-expiratory pressure (PEEP)
– Mean airway pressure (MEAN)
– Plateau pressure (PLAT)
– Peak pressure (PEAK)
F Pressure waveform for airway pressure
G Softkeys (labeling depending on ventilation
mode)
H Virtual flow tubes for O

Changing the ventilation mode

A
1 Select a ventilation mode (A).
– The LED in the key flashes.
– The pressure waveform is replaced by a
dialog window with ventilation settings.
– A message with further instructions (B) is
displayed.
2 Confirm the ventilation mode.
– The LED in the key is continuously lit up.
– The pressure waveform is displayed again.
Instructions for use Fabius Tiro SW 3.n
, Air, N O
2 2
B