Oracle SPARC T7-2 Service Manual page 138

Install the SPM
1. Lower the side of the SPM with the Align Tab sticker at an angle down on the
SPM tab on the motherboard (panel 1).
2. Press the SPM straight down until it is fully seated in its socket (panel 2).
3. Return the server to operation.
See "Returning the Server to Operation" on page
Prior to powering on the server, connect a terminal or a terminal emulator (PC or
4.
workstation) to the SPM SER MGT port.
Refer to Server Installation for instructions.
If the replacement SPM detects that the SPM firmware is not compatible with the existing host
firmware, further action will be suspended and the following message will be displayed:
Unrecognized Chassis: This module is installed in an unknown or
unsupported chassis. You must upgrade the firmware to a newer
version that supports this chassis.
Note -
the portions of firmware in the two components remain consistent.
5. Configure the SPM NET MGT port so that it can access the network, and log in to
the SPM through the NET MGT port.
Refer to Servers Administration or the Oracle ILOM documentation for network configuration
instructions.
138 SPARC T7-2 Server Service Manual • July 2019
Whenever you replace the SPM or the motherboard, update the firmware on the server so
171.