Oracle SPARC T7-2 Service Manual page 154

Install the Motherboard
16. Install the top cover.
See "Replace the Top Cover" on page
Return the server to the normal operating position.
17.
See "Return the Server to the Normal Operating Position" on page
Reconnect the power cords to the power supplies.
18.
See "Attach Power Cords" on page
Prior to powering on the server, connect a terminal or a terminal emulator (PC or
19.
workstation) to the SPM through the SER MGT port.
Refer to Server Installation for instructions.
The SPM detects the host firmware on the replacement motherboard is not compatible with the
existing SPM firmware, further action will be suspended and the following message will be
displayed:
Unrecognized Chassis: This module is installed in an unknown or
unsupported chassis. You must upgrade the firmware to a newer
version that supports this chassis.
Note -
the portions of firmware in the two components remain consistent.
Prepare to download the system firmware.
20.
If necessary, configure the server's NET MGT port so that it can access the network. Log in to
the SPM through the NET MGT port.
Refer to the Oracle ILOM documentation for network configuration instructions.
21. Download the system firmware.
Follow the firmware download instructions in the Oracle ILOM documentation.
Note -
that was installed prior to replacing the motherboard.
If necessary, reactivate any RAID volumes that existed prior to replacing the
22.
motherboard.
If your server contained RAID volumes prior to replacing the motherboard, see
RAID Volumes" on page 155
154 SPARC T7-2 Server Service Manual • July 2019
Whenever you replace the motherboard or the SPM, update the firmware on the server so
You can load any supported system firmware version, including the firmware version
for instructions.
172.
174.
173.
"Reactivate