Oracle SPARC T7-2 Service Manual page 139

6. Download the system firmware.
Follow the firmware download instructions in Servers Administration or the Oracle ILOM
documentation.
You can load any supported system firmware version, including the firmware version
Note -
that was installed prior to replacing the SPM.
If you are replacing an SPM, download the fallback miniroot image for your
7.
hardware and your Oracle Solaris version from My Oracle Support at
support.oracle.com.
Then follow the procedure "Uploading a New Solaris Miniroot Package From SP to Host" in
the Oracle ILOM Administrator's Guide for Configuration and Maintenance.
8. Restore the SPM configuration information you backed up earlier.
At the Oracle ILOM prompt, type:
-> cd /SP/config
-> load -source uritarget
Where acceptable values for uri are: tftp, ftp, sftp, scp, http, https
and target is the location where you stored the configuration information. For example:
-> load -source tftp://129.99.99.99/pathname
Set the time and date on the new SPM.
9.
-> set SP/clock datetime
If TPM was initialized on the replaced SPM, complete these steps:
10.
a.
Reinitialize TPM and reset the tpmadm failover command if it was previously
in use.
For information about initializing TPM using the Oracle ILOM interface to enable failover,
see Securing Systems and Attached Devices in Oracle Solaris
b. Restore the TPM data and keys that were backed up to the new SP you
install.
For information about migrating or restoring TPM data and keys, see
and Attached Devices in Oracle Solaris
11. Power on the server.
11.3.
11.3.
Install the SPM
https://
Securing Systems
Servicing the SPM 139