NetModule NB3000-Line-Hd User Manual page 65

Generally, the connection settings are derived automatically as soon as the modem has
registered and the network provider has been found in our database. Otherwise, it will be
required to con gure the following settings manually:
Parameter
Phone number
Access point name
Authentication
Username
Password
Furtheron, you may con gure the following advanced settings:
Parameter
Required signal strength
Home network only
Negotiate DNS
Call to ISDN
Header compression
Data compression
Client address
MTU
NB3000-Line-Hd User Manual 4.2
WWAN Connection Parameters
The phone number to be dialed, for 3G+ connections this com-
monly refers to be *99***1#. For circuit-switched 2G connec-
tions you can enter the xed phone number to be dialed in
international format (e.g. +41xx).
The access point name (APN) being used
The authentication scheme being used, if required this can be
PAP or/and CHAP
The user-name used for authentication
The password used for authentication
WAN Advanced Parameters
Sets a minimum required signal strength before the connec-
tion is dialed
Determines whether the connection should only be dialed
when registered to a home network
Speci es whether the DNS negotiation should be performed
and the retrieved name-servers should be applied to the sys-
tem
Has to be enabled in case of 2G connections talking to an ISDN
modem
Enables or disables 3GPP header compression which may im-
prove TCP/IP performance over slow serial links. Has to be
supported by your provider.
Enables or disables 3GPP data compression which shrinks the
size of packets to improve throughput. Has to be supported
by your provider.
Speci es a xed client IP address if assigned by the provider
The Maximum Transmission Unit for this interface
56