NetModule NB3000-Line-Hd User Manual page 69

Table of Contents

Advertisement

Prior to setting up an access point, it is always a good idea to run a network scan for getting
a list of neighboring WLAN networks and then choose the less interfering channel. Please
note that two adequate channels are required for getting good throughputs with 802.11n
and a bandwidth of 40 MHz.
WLAN Con guration
Running in client mode, it is possible to connect to one ore more remote access-points.
The system will switch to the next network in the list in case one goes down and return to
the highest-prioritized network as soon as it comes back. You can perform a WLAN network
scan and pick the settings from the discovered information directly. The authentication
credentials have to be obtained by the operator of the remote access point.
Parameter
SSID
Security mode
WPA/WPA2 mixed mode
WPA cipher
Identity
Passphrase
Force PMF
Required signal strength
NB3000-Line-Hd User Manual 4.2
WLAN Client Con guration
The network name (called SSID)
The desired security mode
WPA2 should be preferred over WPA1, running WPA/WPA2
mixed-mode offers both.
The WPA cipher to be used, the default is to run both (TKIP and
CCMP)
The identity used for WPA-RADIUS and WPA-EAP-TLS
The passphrase used for authentication with WPA-PSK, other-
wise the key passphrase for WPA-EAP-TLS
Enables Protected Management Frames
Required signal strength to esablish the connection
60

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NB3000-Line-Hd and is the answer not in the manual?

Questions and answers

Table of Contents