Operation; Safety; Regular Thorough Check; Leds - SICK microScan3 - EFI-pro Operating Instructions Manual

9

Operation

9.1

Safety

9.2

Regular thorough check

9.3

LEDs

8021913/15ZW/2019-11-14 | SICK
Subject to change without notice
DANGER
Hazard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of non-
observance.
Maintenance work, alignment work, fault diagnoses, and any changes to the inte‐
b
gration of the protective device in the machine must only be carried out by quali‐
fied personnel.
The effectiveness of the protective device must be checked following such work.
b
NOTE
This document does not provide instructions for operating the machine in which the
safety laser scanner is integrated.
The protective device must be checked regularly. The type and frequency of thorough
checks is defined by the manufacturer and the operating entity of the machine,
"Testing plan", page 59.
The regular thorough checks serve to investigate the effectiveness of the protective
device and detect any ineffectiveness due to modifications or external influences (such
as damage or tampering).
Carry out the thorough checks according to the instructions from the manufacturer
b
and the machine operator.



Figure 77: LEDs

Status LEDs

1
Additional LEDs for ON state and OFF state
2
Network LEDs
3
4 status light emitting diodes are located directly above the display.
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EFI-pro
9
OPERATION
see
121