Thermo Scientific 410i Instruction Manual page 313

Serial Communication
Parameters
Thermo Fisher Scientific
Appendix D
Gesytec (Bayern-Hessen) Protocol
This appendix provides a description of the Gesytec (Bayern-Hessen or
BH) Protocol Interface and is supported both over RS-232/485 as well as
TCP/IP over Ethernet.
The Gesytec commands that are implemented are explained in detail in this
document. The Gesytec protocol support for the iSeries enables the user to
perform the functions of reading the various concentrations and to trigger
the instrument to be in sample/zero/span mode if valid for that instrument.
This is achieved by using the supported Gesytec commands listed below.
For details of the Model 410i Gesytec Protocol specification, see the
following topics:
"Serial Communication
●
"TCP Communication
●
"Instrument Address" on page
●
"Abbreviations Used" on page
●
"Basic Command Structure" on page
●
"Block Checksum Characters
●
"Gesytec Commands" on page
●
The following are the communication parameters that are used to configure
the serial port of the iSeries to support Gesytec protocol.
Number of Data bits
Number of Stop bits
Parity
Data rate
Parameters" on page D-1
Parameters" on page D-2
D-2
D-2
D-2
<BCC>" on page
D-3
: 7 or 8
: 1 or 2
: None, Odd, or Even
: 1200 to 115200 Baud (9600 is default)
Model 410i Instruction Manual
D-3
D-1