Thermo Scientific 410i Instruction Manual page 284

C-Link Protocol Commands
Communications Configuration
B-44 Model 410i Instruction Manual
dhcp
This command reports the current state of use of the Dynamic Host
Configuration Protocol (DHCP) as on or off. DHCP is used to assign an
IP address to the instrument automatically. The following example shows
that DHCP is on.
Send: dhcp
Receive: dhcp on
set dhcp onoff
onoff = | on | off |
This command enables (on) and disables (off) the DHCP service. When
DHCP is set to on, the instrument gets the IP address, the netmask
address, and the gateway address from a DHCP server. When DHCP is set
to off, the instrument gets these addresses from system memory. The
following example sets the DHCP service to on.
Note If DHCP is changed from on to off and then the IP address, the
netmask address, or the gateway address is changed, you must cycle power
to the instrument before the change takes effect. Until you cycle the power,
the address assigned by the DHCP server will still be used and reported as
the current address. ▲
Send: set dhcp on
Receive: set dhcp on ok
format
This command reports the current reply termination format. The following
example shows that the reply format is 00, which means reply with no
checksum, according to
Send: format
Receive: format 00
set format format
This command sets the reply termination format, where format is set
according to Table B–9. The following example sets the reply termination
format to checksum.
Send: set format 01
Receive: set format 01 ok
Table B–9.
Thermo Fisher Scientific