Display Pixel Test - Thermo Scientific 410i Instruction Manual

Other Measurements
Analog Inputs

Display Pixel Test

Thermo Fisher Scientific
The Other Measurements screen is used to display a list of non-
concentration parameters that can be specified for the selected item
number. The selected item is shown by "<--" after it. In dual or auto range
mode, "HI" or "LO" is displayed to indicate high or low concentrations.
In the Main Menu, choose Service > Setup Run Screen > select a Run
●
Screen > select Run Screen Item > Other Measurements.
OTHER MEASUREMENTS:
>NONE
S/R
LO S/R
HI S/R
INT TEMP
RANGE AVG
BENCH TEMP
BENCH PRES
SAMPLE FLOW
INTENSITY
MOTOR SPEED
BIAS SUPPLY
EXT ALARMS
O2 SENS TEMP
The Analog Inputs screen is used to display a list of analog inputs (none or
analog inputs 1-8) that can be specified for the selected item number. The
selected item is shown by "<--" after it.
In the Main Menu, choose Service > Setup Run Screen > select a Run
●
Screen > select Run Screen Item > Analog Inputs.
ANALOG INPUTS:
>NONE
ANALOG IN 1
ANALOG IN 2
ANALOG IN 3
ANALOG IN 4
RANGE AVG
The Display Pixel Test is used to test the LCD display by toggling between
all pixels on and all pixels off to ensure that they are functioning properly.
The display pixel test is visible only when the instrument is in service
mode. For more information on the service mode, see
earlier in the chapter.

DIAGS ALARM

DIAGS ALARM
Model 410i Instruction Manual
Operation
Service Menu
"Service Mode"
3-93