Connecting External Devices; Terminal Board Pcb Assemblies; I/O Terminal Board; D/O Terminal Board - Thermo Scientific 410i Instruction Manual

Connecting
External Devices
Terminal Board PCB
Assemblies

I/O Terminal Board

Thermo Fisher Scientific
Several components are available for connecting external devices to iSeries
instruments.
These connection options include:
Individual terminal board PCB assemblies
●
Terminal block and cable kits (optional)
●
Individual cables (optional)
●
For detailed information on the optional connection components, refer to
the "Optional Equipment" chapter. For associated part numbers, refer to
"External Device Connection
The terminal board PCB assemblies are circuit boards with a D-Sub
connector on one side and a series of screw terminals on the other side.
This assembly provide a convenient mechanism for connecting wires from
a data system to the analyzer's I/O connectors.
The following terminal board PCB assemblies are available for iSeries
instruments:
I/O terminal board PCB assembly, 37 pin (standard)
●
D/O terminal board PCB assembly, 37 pin (standard)
●
25-pin terminal board PCB assembly, (included with optional I/O
●
Expansion Board)
Figure 2–5 shows the recommended method for attaching the cable to the
terminal board using the included tie-down and spacer.
identifies the connector pins and associated signals.
Note Not all of the I/O available in the instrument is brought out on the
supplied terminal board. If more I/O is desired, an alternative means of
connection is required. See optional
Components" on page 7-6.
"Terminal Block and Cable
Model 410i Instruction Manual
Installation

Connecting External Devices

Table 2–1
Kits". ▲
2-5