Adjusting The Lateral Position Of The Well-Plate Handler - Agilent Technologies 1100 Series Reference Manual

2 Installation

Adjusting the Lateral Position of the Well-plate Handler

The position of the Well-plate Handler must be aligned with the Automation
Interface so that
• the transport position of the Automation Interface is at the same radius as
• the well-plate in the transport position of the Automation Interface is
The adjustment is made in three stages:
1 A preliminary adjustment, described in
2 Well-plate handler teaching, described in
3 A fine adjustment, described in
36
the racks,
located centrally between the gripper fingers.
Well-plate Handler Position"
and gripper are moved manually.
page 39, in which the rotary and vertical positions of the well-plate handler
gripper arm are calibrated.
Position" on page 45, using the Test functions of the ChemStation or
Hand-held Controller to align the Well-plate Handler with the Automation
Interface.
"Preliminary Adjustment of the
on page 37, where the Well-plate Handler arm
"Well-plate Handler Teaching"
"Fine Adjustment of the Well-plate Handler
1100 Series Sample Capacity Extension
on