Table of Contents
Advertisement
1
Installation
To upgrade the stainless steel end plate
If the screws that hold the end plate in position are pan heads, install the
Nanospray Desolvation Upgrade Kit (p/n
any arcing that can occur to the raised head screws.
Before you begin, make sure that you have the parts for
Desolvation Upgrade Kit (p/n G1988-60009)
1 Remove the end plate and the attached screws.
2 Remove the two T-nut high voltage connectors from the white PTFE block.
3 If the existing T-nut connectors are damaged, install the two new
4 Install the new
Figure 5
12
connectors
into the PTFE block.
stainless steel end
secure the end plate. Do not over-tighten these screws!
Flat head gold screws installed on new stainless steel end plate
G1988-60009). This upgrade reduces
Nanospray
listed in
Table 7
plate. Use the two new
Nanospray Ion Source User Guide
on page 62.
T-nut
gold screws
to
Advertisement
Table of Contents
