Part 4 Glider Model Functions; Set Basic Menu Of Glid - RadioLink AT10II Instruction Manual

Please note that nearly all of the BASIC menu functions are the same for airplane (ACRO setup),
sailplane (GLID 1A+1F/ 2A+1F/ 2A+2F setups), and helicopter (HELI setups). The features that are
identical refer back to the ACRO chapter. The glider BASIC menu includes MOTOR CUT and does
not include IDLE-DOWN or THR-CUT.
○ → Note: in all cases where ACRO programming labels channel 3 as throttle, GLID programming
labels channel 3 as ARB (airbrake), since airbrakes are normally operated on channel 3 in gliders.
This includes STK-THR reading STK-ARB.

4.1 SET BASIC MENU OF GLID

This guideline is intended to help you get acquainted with the radio, to give you a jump start on
using your new radio, and to give you some ideas and direction in how to do with this powerful
system.
Goals
Prepare your airplane.
Select the proper MODEL
TYPE for your model. (Ex:
GLID 1A+1F)
[NOTE: This is one of several
functions that require
confirmation to make a change.
Only critical changes such as a
MODEL RESET require
additional key strokes to accept
the change.]
Name the model
Note that you do not need to
do anything to 'save' or store
this data.
REVERSE servos as needed for
proper control operation.

PART 4 GLIDER MODEL FUNCTIONS

Steps
Install all servos, switches, receiver per your model's instructions. Turn on
transmitter then receiver; adjust all linkages so surfaces are nearly centered.
Mechanically adjust all linkages to get as close as possible to proper control
throws and minimize binding prior to radio set up.
Check servo direction and throws.
Make notes now of what you will need to change during programming.
In the BASIC menu, open
PARAMETER submenu.
Choose proper MODEL
TYPE. Ex: GLID
(1A+1F).
Confirm the change.
Close submenu.
In BASIC menu open the
MODE SEL submenu.
Input airplane name.
Close the submenu.
In the BASIC menu, open
REVERSE.
Choose desired servo and
reverse its direction of
travel.
(Ex: reverse rudder
servo.)
Inputs
Turn on the transmitter.
BASIC.(If ADVANCE
PARAMETER.
to MODEL TYPE
GLID(1A+1F), press
Displays.
to confi rm.
menu.
to MODEL SEL.
character of model's name is highlighted).
to change the 1
to next character and repeat.
to REVERSE.
to 4:RUDD,
for 1 sec. 'Are you sure?' Displays.
confirm.
To BASIC menu.
54
Radiolink Electronic Ltd
www.radiolink.com
for 1 sec. to
again.) to choose
, to
for 1 sec. Are you sure?
Return to BASIC
, to NAME.（1
character. to confirm.
st
to return.
REV is highlighted. Press
st
to