Testing The Optical Speed Module - HBM T10FS Mounting Instructions

46

7.4.2 Testing the optical speed module

When required, you can test the correct functioning of the speed measuring
system.
Remove the cover of the stator housing.
Turn the rotor by at least 2 min
If both the control LEDs come on while you are turning the rotor, the speed
measuring system is properly aligned and fully operational.
Fig. 7.6: Control LEDs of the speed measuring system
CAUTION
When closing the cover of the stator housing, make sure that the internal
connection cables are positioned in the grooves provided and are not
caught up.
HBM
1
.
Green control LEDs
T10FS
A0785 14.0 en