Application - HBM T10FS Mounting Instructions

11
T10FS
2

Application

T10FS torque flanges record static and dynamic torque on fixed or rotating
shafts and also return RS 422 signals with direction of rotation information to
determine the speed. With an optical measuring system, a reference pulse can
also be output with the speed pulses. Test beds can be extremely compact
because of the short construction of the measurement flanges. They offer a
very wide range of applications.
In addition to conventional test bench applications (motor, roller and gear test
benches) new solutions are possible for torque measurements partly integrated
into the machines. Here, you benefit from the T10FS torque flanges' special
characteristics:
• low rotor weights
• low mass moments of inertia
• small outside diameters
• no bearings, no slip rings
Thanks to the bearing free design and the contactless transmission of
excitation voltage and measured values, there are no friction or bearing
heating effects.
Torque flanges are supplied for nominal (rated) torques from 100 N⋅m to
10 kN⋅m. Depending on the nominal (rated) torque, maximum speeds of up to
1
24 000 min are permissible.
T10FS torque flanges are reliably protected against electromagnetic
interference. They have been tested with regard to EMC according to the
relevant European standards, and carry the CE mark.
A0785 14.0 en HBM