Fixing The Mounting Elements; Installing The Torque Flange With The Speed; Measuring System - HBM T10FS Mounting Instructions

T10FS

4.8.1 Fixing the mounting elements

1. Place the rotor with the identification plate upward on a flat base.
For the optical speed measuring system only:
Hold the stator at a slight slant and push it over the rotor until the slotted
disc is located in the optical sensor (Step A, Fig. 4.9). Tilt the stator over the
rotor until the antenna ring completely covers the transformer (Step B,
Fig. 4.9).
B
Transformer
Slotted
disc
Fig. 4.9: Installing the mounting elements
2. Hold the stator centrally over the rotor and one after the other, push the
three mounting elements between the transformer and the antenna ring.
The mounting elements should be evenly distributed around the
circumference (approx. every 120_).
3. Screw the fastening screws of the mounting elements into the tapped holes
of the flange and gently tighten them by hand.
4.8.2 Installing the torque flange with the speed measuring system
1. Mount the torque flange in the shaft run so that the bearing surface of the
stator base lies on the prepared mounting surface free from play and stress.
2. Fasten the rotor with 8 screws in the shaft run (for the property class, see
Table 4.1, Page 19). Initially, the screws should only be hand tight.
3. Compensate for any possible misalignment of the stator by putting adjusting
washers underneath or by adjusting the base.
4. Fasten the base retaining screws; only tighten them gently at first, so that
the mounting elements do not get jammed.
5. Remove the mounting elements (if a mounting element should get jammed,
try to move it to the left or right).
A0785 14.0 en
Antenna ring
A
Optical sensor
25
HBM